This photo shows the two points that we attached the String Lights to the house. Attach the two hose clamps to the EMT.
These are all plugged into 2 electrical outlets on our deck.
How to attach lights to deck railing. Installing Outdoor Rope Lights to Deck Railing. Integrating your deck rail lighting into the post caps is simple. Plug the first string of lights into the extension cord and then wrap the string of lights around the deck railing in a tight spiral clockwise until you get to the end of the string of lights.
Outside mounted rails rail post attachment baluster spac. Make sure you check for level as you are screwing them in. Using wood screws attach each pole to the back of the deck.
Using a ½ in drill bit drill a hole from the side of the handrail into the core of the deck post. Starting with the string light closest to your power supply use a staple gun to fasten the lights under your railing. If you prefer light only the main length of the railing and leave the sides open.
To softly light your deck railings and posts choose post-cap lights that focus the light downwards. Installation is easy with a simple plug-and-play wiring system. Slip the tubing into the hole that was drilled in to the deck rail.
I started the screws in the bracket holes to make it easier to drill upside down without losing them in the grass below. Attach poles to the deck. Thin Wooden Posts To Hang Lights On The Deck Railing.
Hold the lights along the deck and mark where you want to attach them. Add additional strings of lights and continue the spiral clockwise pattern until you get to the end of the railing. Firstly lay your lights along the deck and where you want to hang them and mark the point where they need support.
People on deck during sunset outdoor living. Drill a hole for the EMT in the deck railing. The hooks are in the posts and he wrapped the wires around the hooks once to secure them.
Measure your string lights to run the entire length of the deck railing. We attached the 60 Wooden Garden Stake with screws that were long enough to go thru the top part of the deck railing and again down lower for extra support. Make sure your string lights are attached to an extension cord or theyre close to an outlet before you begin installing them.
Then install support of 8 to 10 feet apart to hold your string lights and light up your deck railing. The overhang was just wide enough to attach the brackets underneath. Generally builders will install rail lights in the center of the span of the railing to provide illumination between the posts.
If you plan to attach your lights directly onto your deck the first thing you should do is run the lights along the length of your deck keeping the. These adhesive clips would make it easy to attach to the underside of your deck railing. We used large hooks on the house and hung them high so the string lights would be tall enough to walk under.
Installation was pretty straightforward. Screw a hook on to the top of each pole as well as to the side of the house where the string lights will start and end. At the end of the wire the extra sockets were cut off and he used a waterproof electrical tape to tie them off and keep water from getting in.
One goes on the top of the pole to keep the wire rope in place and one at the bottom is to keep it from sliding down through the 2 hole straps that will be attached to the deck post. Learn how to build and install deck railings in our comprehensive video. Topics include inside vs.
Many deck railing manufacturers offer post caps with integrated lighting. Step 4 Drill the wire hole. We used two screws for each post to ensure they were stable.